Calibration

• The Calibrate RF Gain wizard performs RF Gain calibration, using a calibrated signal source. You may also set the RF Gain calibration table to the "factory default" values.
• The Calibrate Transmitter Gain wizard automates the Transmitter Gain calibration procedure.
• The Enter TCXO Data dialog supports entry of temperature compensation calibration data for your KCTXO-3 1 ppm High Stability Reference Oscillator.

The speed of these operations depends upon the K3 CONFIG:RS-232 speed setting.

Buttons on this page are enabled only when the K3 Utility has established communications with your K3.

Calibrate RF Gain

Click to start the RF Gain calibration procedure. A 50 microvolt (S9) signal source, such as the Elecraft XG1 or XG2 Receiver Test Oscillator, or other signal generator, is required to perform calibration. If you do not have a signal generator available, a "factory default" RF Gain calibration table may also be used.

RF Gain calibration requires MCU revision 03.20 (or later) and DSP version 02.13 (or later). The "Calibrate RF Gain" button is disabled if your K3 has earlier firmware revisions installed.

Calibrate Transmitter Gain

Click to start the Transmitter Gain Calibration wizard, used to automate the Transmitter Gain Calibration procedure described in the K3 Owner's Manual.

Enter TCXO Data

Click to start the Enter Temperature Compensated Crystal Oscillator Data dialog. This dialog allows you to enter the temperature calibration data that accompanied your KCTXO3-1 1ppm High Stability Reference Oscillator.